Tractorpoint Login

print < Tractorpoint Login

Search for =

Topic

$I was able to fabricate skid plates rather easily for my blade. The blade has holes already drilled in it (to offset the mounting to the left or right). I simply cut some 1/2" x 3" wide bar stock into 2 pieces about 12" long, then bent the front and back 3 " up to a 45 degree angle using the torch. I welded a 18" length of unistrut straight up from the middle of each, and I bolt them on using 1/2" bolts and unistrut nuts . Crude ascii drawing from the side: || | || Blade | ||unistrut | || / || \____||___/ skid plate I have plenty of adjustment available with the unistrut, but I have been running them tight to the bottom of the blade. I still move a little gravel, but I need to clear almost all of the snow for our cars to climb the incline in our driveway.$ Snow Removal with Rear Blade
Snowblowers / Snow Plows
Replies 20 Post by Mike Broich